• A-10 SS - BTEX ELIMINATOR A-FRAME SYSTEM
  • BTEX ELIMINATOR SYSTEM II
  • J-5000C Field
  • S.T. 5-120 Quad. Eliminator1
  • BTEX ELIMINATOR A-FRAME SYSTEM
  • BTEX ELIMINATOR SHELL & TUBE SYSTEM
  • BTEX ELIMINATOR A-FRAME SYSTEM
  • BTEX ELIMINATOR SYSTEM III
  • BTEX ELIMINATOR SYSTEM I
  • JATCO Environmental J-7000 Tank
  • Environmental Tanks

JATCO Inc., Manufactures environmental solutions for the oil and gas production and transportation industries. Solutions include cost effective, and reliable equipment, designed to prevent pollution of soil, water, and the atmosphere.

JATCO Inc., are specialists in: Air Cooled Condensers,BTEX Systems,Bundle Condensers,Tube Condensers,Vapor Recovery Systems and Vapor Separators.

COST-EFFECTIVE, ENVIRONMENTAL SOLUTIONS

At JATCO we are not environmental activists, we are active Environmentalists. Every product exiting our door is saving our environment globally! We continue to strive for better methods to control pollution while allowing our customers to continue production of vital energy resources. We do this by providing the best environmental solutions for the oil, gas and transportation industries. Soil, air and water pollution prevention is paramount to what we do.

Our planet’s future is at stake!

CAPABILITIES

BTEX Units
Environmental Tanks
Air Cooled BTEX Condenser
Shell & Tube BTEX Condenser
JATCO Vapor Recover Unit

JATCO BTEX Eliminator Guarantee

The system operation of the JATCO BTEX “Eliminator” is able to achieve stack test results in excess of 95% destruction efficiency by routing the pre-condensed still column vapors to the main burner and inducing this low pressure V.O.C.’s into the primary air inlet of the original burner using our patented JATCO compound injector burner assembly. When re-boiler temperature is reached, a valve stops the V.O.C. flow to the main burner and opens to route the V.O.C.’s to the exhaust stack, through the igniter (to be installed with unit). The igniter consists of a stainless steel nipple with a nickel alloy wire coil. As the main burner is on its firing cycle, the exhaust gases keep this coil red hot by cumulating heat in the fire tube. After the main burner shuts off, and V.O.C.’s are routed to the exhaust stack, the coil will ignite or flash the vapor for a period until there is free air oxygen dilution. The actual stack testing will show burner/on burner/off cycles and concentrations. It is also a note that general operation of standard glycol re-boiler dehydration, when the burner is on is when you achieve the flash/flux around the fire tube and when it shuts off the V.O.C output from the still column diminishes rapidly.

JATCO Environmental Inc. stands behind all of the testing performed on our units and will purchase any unit back that does not perform to these standards.

  • J-5000cx

    The J-5000cx is a 10 gallon tank and will handle 310 gph, and can be configured to meet any standard or application you may need. (more)

  • Jatco Vapor Recovery Unit

    The JATCO Vapor Recovery Unit (JVR) was designed to recover VOC vapors at low pressure and re-inject into compressor suction or pressurized flare line by using high pressure drive gas across a venturi ejector. Our system uses Kimray control valves to operate the venturi suction only as needed, instead of full time drive gas operation. (more)

  • J-7000

    The J-7000 is a 30 gallon tank with a capacity of 1400 gph, and can be configured to meet any standard or application you may need. (more)